Kit includes 2 x spacers + 8 extra long sleeved nuts. No need to install longer studs.Suitable for all original Ford wheels. Suitable for most after-market wheels. Spaces each wheel by 5mm (10mm per axle). Can be fitted to the front or rear. They can also give you the much needed clearance required when fitting some after-market alloy wheels. NOTE: It is your responsibility to check that you have the necessary wheel arch clearance. This kit includes everything you see in the picture. 2 x Wheel spacers (5mm thick). Made from lightweight aircraft grade aluminium. 8 x Extra long nuts with deeper shafts (means you do not need to fit longer studs). This is everything required to space out your wheels and increase the track by 10mm (approx 3/8 inch) overall. How do the extra long sleeved nuts work? When fitting wheel spacers you would normally have to install longer wheel studs. This involves removing the wheel hub, knocking out the old studs and replacing them with new longer ones. It can be a real pain! Because the nuts in this kit are designed with a special shaft at the base, they fit deeper into the wheel and engage with more of the thread. The wheel spacers can be fitted with standard length studs.
This will greatly reduce the time, cost and hassle involved with fitting them. Hub-centric design = NO wheel vibrations! The spacers in this kit should NOT be confused with cheap universal items! They are precision machined and designed for a perfect hub-centric fit.
This means they fit perfectly central on the hub and cannot disturb the vehicles wheel balance. The spacers are machined from billet aluminium - not cheap cast aluminium and they are clear anodised for long lasting corrosion protection. Be sure that you have the necessary clearances available to fit these spacers.Please measure the space available inside the arch lip and with respect to other suspension components BEFORE ORDERING. THIS PART IS YOUR RESPONSIBILITY!
What Ford vehicles will this kit fit? This kit can be used with most Ford vehicles that have a 4-stud wheel pattern. If in doubt please use the application list near the top of this page, or the dimensions specified below to check suitability for your particular vehicle.
Please ensure you have the necessary wheel arch lip clearance to accommodate the extra width. Will this kit fit original Ford wheels? Yes - this kit can be used with any Ford 4-stud alloy wheels (except for the RS wheels of the 1970's Escorts). Will this kit fit after-market wheels?
This kit will also fit the majority of after-market alloy wheels, but please check the nut dimensions before purchasing as there are many different types of after-market wheels available. The most important things to check for are; (A) that your wheels require nuts with a'tapered' seat, and (B) that the stud holes in your wheels are at least 16mm in diameter (to allow the nut's shaft to pass through). Specifications Spacer material: Billet aluminium Spacer finish: Clear anodised Spacer thickness: 5mm Spacer overall diameter: 139mm Spacer centre hole (hub centre diameter): 63.4mm Spacer PCD of bolt holes: 108mm Thread size: M12 x 1.5 Overall nut width: 25mm Overall nut height: 34mm (inc head & shaft) Shaft width of nut: 15.5mm Nut internal thread depth: 29mm Nut seat type: Tapered (Cone shaped) 60° Nut material: High tensile steel Nut Finish: Bright Zinc Plated Nut spanner size: 19mm Hex Our stock code: 2H8VS. Goods are packaged securely to arrive to you in perfect condition.
The item "5MM ALLOY WHEEL SPACERS + EXTRA LONG NUTS FOR FORD (4x108 63.4 PCD) SHIM 2H8VS" is in sale since Thursday, March 5, 2015. This item is in the category "Vehicle Parts & Accessories\Car Wheels, Tyres & Trims\Wheel Spacers". The seller is "tech_world_direct" and is located in Essex.This item can be shipped worldwide.