Ford 1625 Cross Flow Built by Burton Power. All new Bottom end bearings. Kent 285 Cam Kit with Springs.
Ported & Polished Head with stainless big valves with new guides & seats. Inlet 41.33 mm Exhaust 33.66 mm Duplex Timing Chain Kit. Piper XF Distributor with Lumenition Electronic Ignition. Dellorto Carburettors - Twin 40's 4 Speed Sports Gearbox. I fitted the engine and carbs into my Mk3 Ford Cortina, along with a new 5 speed gear box.
I've covered 700 miles since fitting the engine without any issues whatsoever, - and done the mandatory 500 mile service; Oil & Filters, etc.. To be fair, I've had some difficulty in getting the carburettors and electronic ignition set up correctly as I have limited knowledge and equipment in this field, - it would benefit from getting set up properly, perhaps on a rolling road / dyno run, but the engine runs clean and literally pulls like a train, (this despite being married to the taller 5 speed box) it just needs the ancillaries set up correctly ie; the carb & Ignition - by somebody with more knowledge / experience than myself. The engine is currently still fitted to my Mk3 Cortina and I'm still occasionally driving it, therefore the. The gearbox - a 1600, 4 speed sport box - I haven't fitted / used.
Has a new clutch, unsure of the make, is new but has some surface rust, also has a flywheel which also has a bit of surface rust. Car is located in Scotland, 17 miles north of Perth. The item "Ford 1625 Cross Flow Engine by Burton Power, Escort Mk1 Mk2, Cortina Mk3" is in sale since Saturday, July 10, 2021.
This item is in the category "Vehicle Parts & Accessories\Car Parts\Engines & Engine Parts\Complete Engines". The seller is "mumford1717" and is located in Pitlochry, Perthshire and Kinross. This item can't be shipped, the buyer must pick up the item.